| Description |
: |
Place the rubber pad and mounting plate over the exposed pegs. Screw the tightening nuts onto the pegs in an alternating order, much like you would tighten the lugs on a wheel. I tighted each screw a few turns then moved on to the next. After they were tight, I went back around and gave each screw another half turn. Pick up the card and make sure the sink is touching the GPU and each memory chip; if not, tighten each screw until it does. Place the backside memory heat spreader on the card as shown using the supplied thermal pads. Mine didn\'t have backside memory, but yours might. |
